![]() They should release at least 50 feet of the fishing line out to increase your chances of triggering a second strike. Crew members should be prepared to release the drag on the lure that was not hit once a wahoo bites the line.Wahoo feeds in packs, so if you find one, chances are there are more around after you reel in your first one, circle back to the same spot at least two more times to attract more.Ideally, you should be going at 12 to 14 knots to troll or 18 knots if you are using certain lures. Trolling speed is key whether you have a 4 or 6 lure spread for wahoo.Tips and Techniques on Wahoo Fishingįollow these tips to increase your possibility of catching big wahoo: High-Speed Wahoo Trolling Tips To prevent the lure from tangling, trim the skirt in front of the stinger hook, and you are done. Use a small haywire twist to make a loop at its end for the snap swivel. Make a few more wraps around the wire leader.Īfter that, slide the lure on the leader. Secure the bait by threading the copper wire through the eye socket and make several wraps right behind the pin and then around the jaws in front of it. Then pass the wire leader’s tag end through the baitfish’s lower jaw and out through its upper jaw. Then, work the bait onto the shank and pull out the point through the bait’s belly. To make this setup, hold the stinger strands off to the small baitfish’s side and insert the lead hook into the throat. With this special rig, those strikes can turn into successful hookups. ![]() Wahoo typically strikes the back half of the bait. Those razor sharp teeth and hooks can do a lot of damage if you don’t keep an eye on them. When it does this, at least one of those hooks will dig in deep and stay there no matter how hard the fish struggles. Wahoo is notorious for throwing hooks off using aggressive headshakes. This rig offers a unique advantage in the form of two separate stinger strands that swing freely along the baitfish body you use. Secure the set with a haywire twist while making sure that the hook point in an outward direction. ![]() Take the smaller hooks and add them to the stinger wire, making sure they are about halfway down the baitfish’s body.9 wire and connect each to the hook eye of the lead hook with a haywire twist. Based on the size of the baitfish you are using (preferably ballyhoo fish), cut leader lines about 4 to 5 inches long from the no. Then, twist a strand of the copper wire onto the connecting loop.Leave it at one end as well as a few inches of the tag end upright to the hook point to create a pin rig. To make the rig, first cut 4 feet of No.9 wire and haywire twist a 7/0 hook to one end. ![]() Make sure you have plenty for a full day of fishing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |